Service Hotline::

+86-577-61661881

JXD/JXL type groove clamp (AMP clamp)

Wedge clamp is suitable for non-bearing connection or branching between insulated aluminium strands, aluminium strands, copper strands or steel-cored aluminium strands in overhead distribution lines. The insulating cover and clamp are used together to provide insulation protection.

  • Type: JXD/JXL-1-4
  • Material: Aluminum
关闭
产品咨询
客服热线:400-139-4191


Installation instructions

The wedge clamp consists of C-shaped wedge shell and wedge block (as shown in the figure). The groove size between C-shaped wedge shell and wedge block is directly related to the diameter of the wire to be installed. Dimensions and shapes of grooves are determined by the designer and manufacturer. Therefore, when choosing wedge clamp, users only need to provide the model and cross-section size of the main and branch wires at the same time.

Selection of clamp

The wedge clamp consists of C-shaped wedge shell and wedge block (as shown in the figure). The groove size between C-shaped wedge shell and wedge block is directly related to the diameter of the wire to be installed. Dimensions and shapes of grooves are determined by the designer and manufacturer. Therefore, when choosing wedge clamp, users only need to provide the model and cross-section size of the main and branch wires at the same time.

The wedge clamp consists of C-shaped wedge shell and wedge block (as shown in the figure). The groove size between C-shaped wedge shell and wedge block is directly related to the diameter of the wire to be installed. Dimensions and shapes of grooves are determined by the designer and manufacturer. Therefore, when choosing wedge clamp, users only need to provide the model and cross-section size of the main and branch wires at the same time.

The choices of wedge clamps are shown in Table 1 and Table 2.

Selection table

1556073227483026.jpg


Phone
E-mail
map
QQ